00:05The 501321 cable. Gland consists of three key components,

00:10entry and IP seal and the back nut.

00:13This exe cable Gland is designed for use with non armoured elastomer and plastic insulated

00:19cables. This cable Gland may be used with brady cables

00:23where the braid and outer sheath pass into the enclosure.

00:27The braid must be suitably terminated inside the enclosure assembly.

00:31Instructions are provided with Hawk cable lands or can be downloaded by the Hawk website allow

00:38sufficient length of cable to suit the equipment.

00:41The cable is being terminated into past the cable through the

00:47cable Gland. Please note if the equipment has a threaded

00:51entry, it may be advisable to screw the cable Gland into the equipment to prevent twisting of

00:57the cable. The method of installation may vary depending

01:01on the enclosure type, hold the entry position with a

01:09spanner or wrench to prevent rotation and tighten the back nut using a spanner or wrench

01:14until resistance is felt between the seal and the cable then turn the back nut through a

01:20further half to one full turn to complete the inner seal installation is complete