Anchor, Lead Section, SS150, 8/10/12 X 5ft Rock-It
Brand: Chance
Catalog ID: C1101791
Square Shaft (SS 150) Lead Section Rock-It, 5' (1524 mm) long with 8" (203 mm) - 10" (254 mm) -12" (304 mm) Helices.
The ROCK-IT™ lead section by Hubbell Power Systems is an innovative solution to help penetrate thin rocky layers without pre-drilling. The single carbide tip design was developed after site testing of several rock anchor configurations to provide an economical, yet proven solution to reach load-bearing depths.
- Square Shaft Lead Sections are assembled to Square Shaft Extension with through bolt.
- The helical shaped plates do not auger into the soil but rather screw into it with minimal soil disturbance
- Hot dipped galvanized per ASTM A153
- Capacity of anchor can be determined by measuring installation torque
General
Application
Helical Anchoring
Catalog Number
C1101791
Coating
Galvanized
Number of Helices
3
Product Type
SS150
Strength Note
Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength
70000 lb.
Torque Rating
7000 ft-lbs
Type
Lead Sections
UPC
096359871040
Dimensions
Anchor Helix Diameter(s)
8 in - 10 in - 12 in
Dimensions
60.000 in x 12.000 in x 12.000 in
Height
12 in
Length
60 in
Width
12 in
Force Related
Strength Note
Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength
70000 lb.
Configuration
Number of Helices
3