Anchor, Lead Section, SS175 6/8/10 X 5 feet Rock-It
Brand: Chance
Catalog ID: C1101404
Square Shaft (SS 175) Lead Section 5' (1524 mm) long with 6" (152 mm) - 8" (203 mm) - 10" (254 mm) Helices.
The ROCK-IT™ lead section by Hubbell Power Systems is an innovative solution to help penetrate thin rocky layers without pre-drilling. The single carbide tip design was developed after site testing of several rock anchor configurations to provide an economical, yet proven solution to reach load-bearing depths.
- Square Shaft Lead Sections are assembled to Square Shaft Extension with through bolt.
- The helical shaped plates do not auger into the soil but rather screw into it with minimal soil disturbance
- Hot dipped galvanized per ASTM A153
- Capacity of anchor can be determined by measuring installation torque
General
Application
Helical Anchoring
Catalog Number
C1101404
Coating
Galvanized, ASTM A-153
Number of Helices
3
Product Family
SS175
Product Type
Anchor Lead Section
Shaft Type
Square Shaft
Strength Note
Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength
- 100000 lb.
- 100000 lb.
Torque Rating
10500 ft-lbs
Type
Lead Sections
Dimensions
Anchor Helix Diameter(s)
6 in - 8 in - 10 in
Dimensions
60 in x 10 in x 10 in
Height
10 in
Length
60 in
Width
10 in
Force Related
Strength Note
Ultimate strength ratings apply to properly installed anchors only. Failure to install within 5 ° of alignment with the guy load may significantly lower strength.
Tensile Strength
- 100000 lb.
- 100000 lb.
Configuration
Number of Helices
3
Logistics
Standard Package
1