00:03Welcome And thank you for choosing Hubbell.

00:13To install this Hubbell in line single pull device.

00:16You will need wire strippers, a utility knife, wire cutters, a 7

00:2332 inch allen wrench and linesmen pliers.

00:28Let's begin. Measure the cable jacket diameter.

00:32Then cut the body plug with the utility knife at the groove marked for the cable jacket

00:37diameter. Push the cable through the body exposing six inches,

00:43then strip the jacket 1 3/8 inch to 1.5 inches with a wire cutter.

00:51Now wrap the strain relief brass wire around the cable jacket.

00:57Twist two full turns compressing the cable jacket with linesman pliers squeeze

01:04strain relief brass wire ends together, wrap copper foil tightly around the conductor

01:10strands and strain relief brass wire to be flush.

01:17Insert the wire bundle in the contact as far as possible.

01:23Insert two set screws and tighten securely to 200 inch pounds with 7 32 inch allen

01:29wrench set screws must either be flush or below

01:35flush to prevent interference with body align the large

01:42arrows on the body with the termination screws for male and female contact if necessary,

01:49lubricate inside body and outside of contact with lubricant.

01:55Now pull the contact into the body until the whole contact is visible in body pole.

02:02Insert, retaining screw through the threaded hole and into the contact.

02:07Tighten the retaining screw to a 25 inch pound max torqu. And there you have it,

02:13you have now installed a Hubbell In Line Single Pole Connector Device.

02:19All of these instructions can be found on this website for questions,

02:24call Hubbell technical support and remember always think safety.